37718 Drum Servo DRS: Drum target velocity invalid for PLL calculations Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The target drum velocity is invalid because it was not successfully achieved A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. This error occurs when the drum servo control subsystem is queried for its current target velocity and the last attempt to achieve this target velocity was not successful. The target velocity is therefore unusable for calculations required to set up the hardware Phase-Locked-Loop (PLL) 26-Oct-2001 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:09 2008 PST